These applicators increase productivity and use an exclusive label edge detector to
automatically sense the edge of the label to provide complete accurancy when it
comes to dispensing of labels. Each of the three applicators can dispense any
label type and requires no additional liner tool, cassettes or cartidges.
In addition, easy side web loading reduces the time to thread and the applicators have a positive
feed roller.
Specifications
Model
Label Size (stroke)
Label Size (width)
Maximum Outer Diameter
Towa AP65-30
20-60mm
20-30mm
100mm
Towa AP65-60
20-60mm
25-60mm
100mm
Towa AP65-100
20-60mm
55-100mm
100mm
How to Determine Your Needs
Please follow this guide to help you select the appropriate dispenser for your needs.
Dimension
30mm
60mm
100mm
Roll Size
88.9mm OD
3 1/2"
88.9mm OD
3 1/2"
88.9mm OD
3 1/2"
Core Size
25.4mm ID
1"
25.4mm ID
1"
25.4mm ID
1"
Max. Label Width
28.575mm
1 1/8"
57.15mm
2 1/4"
98.425mm
3 7/8"
Min. Label Width
20mm
13/16"
25mm
15/16"
55mm
15/16"
Max. Label Repeat
63.5mm
2 1/2"
63.5mm
2 1/2"
63.5mm
2 1/2"
Min. Label Repeat
6.35mm
1/4"
6.35mm
1/4"
6.35mm
1/4"
Die Cut Only
YES
YES
YES
Key: OD refers to 'Outer Dimension' of the roll, ID refers to 'Inner Dimension' of the core. 'Label Repeat'
indicates the distance from the beginning of one label to the beginning of the next label.
Instructions For Use
Step 1.
Remove label guide by turning to the
right and place your roll of labels onto the spooler. Replace the guide by
pressing inward and turning to the left.
Step 2.
Pull labels under the transparent pressure plate. Open the bottom gate,
releasing the latch marked "OPEN" (do not force), and thread label edge along
the bottom gate.
Step 3.
Close the bottom gate by returning the latch marked "OPEN" back into the locked
position. The serrated edge is used to remove the excess label liner.
Step 4.
Labels are released as you squeeze the handle. As you squeeze, pull the
applicator along in a fluid motion over the surface of the item being labeled.
Maintenance
Unscrew 2 screws. Easily remove stuck label by solvent for strong adhesive.
Note:
It's unnecessary to make a slit or slot on backing paper for feeding of labels.
Film with less than 50 microns thickness is unacceptable.
Use only die-cut labels.
A cotton-swab moistened with ALCOHOL, is recommended to wipe adhesive from Mecha-Sensor
We are able to offer a number of different labelling guns, depending upon your specific requirements. To
discuss your needs, please do not hestitate to get in touch and we'll be
happy to talk you through the options.
