Label Applicators – Towa Label Applicator Technology: These label applicators increase productivity and use an exclusive label edge detector to automatically sense the edge of the label to provide complete accuracy when it comes to dispensing of labels. Each of the three applicators can dispense any label type and requires no additional liner tool, cassettes or cartridges.
In addition, easy side web loading reduces the time to thread and the applicators have a positive feed roller.
Specification
Key: *OD refers to the outer dimension of the roll. **ID refers to the inner dimension of the core. ***Label Repeat refers to the distance from the beginning of one label to the beginning of the next label.
Instructions For Using Label Applicators
-Step 1. Remove label guide by turning to the right and place your roll of labels onto the spooler. Replace the guide by pressing inward and turning to the left.
-Step 2. Pull labels under the transparent pressure plate. Open the bottom gate, releasing the latch marked “OPEN” (do not force), and thread label edge along the bottom gate.
-Step 3. Close the bottom gate by returning the latch marked “OPEN” back into the locked position. The serrated edge is used to remove the excess label liner.
-Step 4. Labels are released as you squeeze the handle. As you squeeze, pull the applicator along in a fluid motion over the surface of the item being labeled.
Maintenance. Unscrew 2 screws. Easily remove stuck label by solvent for strong adhesive.
Notes:
- It’s unnecessary to make a slit or slot on backing paper for feeding of labels.
- Film with less than 50 microns thickness is unacceptable.
- Use only die-cut labels.
- A cotton-swab moistened with ALCOHOL, is recommended to wipe adhesive from Mecha-Sensor
Expertise and Knowledge 
Customer Focus and Trust 
Speed and Efficiency 
Diverse Product Range 
Advanced encryption keeps your data safe and secure