Die Cut Label Applicators – Towa Label Applicator Technology

Towa Label Applicators

Towa Label Applicators

These applicators increase productivity and use an exclusive label edge detector to automatically sense the edge of the label to provide complete accurancy when it comes to dispensing of labels. Each of the three applicators can dispense any label type and requires no additional liner tool, cassettes or cartidges.

In addition, easy side web loading reduces the time to thread and the applicators have a positive feed roller.

Specification

Model

Label Size (stroke)

Label Size (width)

Max. Outer Diameter
Towa AP65-30

20-60mm

20-30mm

100mm
Towa AP65-60

20-60mm

25-60mm

100mm
Towa AP65-100

20-60mm

55-100mm

100mm

Determining Your Needs

Dimension

30mm

60mm

100mm
Roll Size

88.9mm OD*
3 1/2“

88.9mm OD
3 1/2“

88.9mm OD
3 1/2“
Core Size

25.4mm ID**
1″

25.4mm ID**
1″

25.4mm ID**
1″
Max label Width

28.757mm
1 1/8″

57.15mm
2 1/4″

98.425mm
3 7/8″
Min Label Width

20mm
13/16″

25mm
15/16″

55mm
2 1/4″
Max Label Repeat

63.5mm
2 1/2″

63.5mm
2 1/2″

63.5mm
2 1/2″
Min Label Repeat***

6.35mm
1/4″

6.35mm
1/4″

6.35mm
1/4″
Die Cut Only

YES

YES

YES
Key: *OD refers to the outer dimension of the roll. **ID refers to the inner dimension of the core. ***Label Repeat refers to the distance from the beginning of one label to the beginning of the next label.

Instructions For Use

Label Applicator Instructions for Use

Step 1. Remove label guide by turning to the right and place your roll of labels onto the spooler. Replace the guide by pressing inward and turning to the left.

Step 2. Pull labels under the transparent pressure plate. Open the bottom gate, releasing the latch marked “OPEN” (do not force), and thread label edge along the bottom gate.

Step 3. Close the bottom gate by returning the latch marked “OPEN” back into the locked position. The serrated edge is used to remove the excess label liner.

Step 4. Labels are released as you squeeze the handle. As you squeeze, pull the applicator along in a fluid motion over the surface of the item being labeled.

Maintenance. Unscrew 2 screws. Easily remove stuck label by solvent for strong adhesive.

Notes:

  • It’s unnecessary to make a slit or slot on backing paper for feeding of labels.
  • Film with less than 50 microns thickness is unacceptable.
  • Use only die-cut labels.
  • A cotton-swab moistened with ALCOHOL, is recommended to wipe adhesive from Mecha-Sensor
Call us now on 01332 864895 for more details or fill in the form below